Avalue EBM-BYT Bedienungsanleitung Seite 16

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 75
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 15
EBM-BYT User’s Manual
16 EBM-BYT User’s Manual
2.2 Jumper and Connector List
You can configure your board to match the needs of your application by setting jumpers. A
jumper is the simplest kind of electric switch.
It consists of two metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To “close” a jumper you connect the pins with the clip.
To “open” a jumper you remove the clip. Sometimes a jumper will have three pins, labeled 1,
2, and 3. In this case, you would connect either two pins.
The jumper settings are schematically depicted in this manual as follows:
A pair of needle-nose pliers may be helpful when working with jumpers.
Connectors on the board are linked to external devices such as hard disk drives, a
keyboard, or floppy drives. In addition, the board has a number of jumpers that allow you to
configure your system to suit your application.
If you have any doubts about the best hardware configuration for your application, contact
your local distributor or sales representative before you make any changes.
The following tables list the function of each of the boards jumpers and connectors.
Jumpers
Label
Function
Note
JBAT1
Clear CMOS
3 x 1 header, pitch 2.00mm
JRI1
Serial port 1 pin9 signal select
3 x 2 header, pitch 2.00mm
JRI2
Serial port 2 pin9 signal select
3 x 2 header, pitch 2.00mm
JVR1
LCD backlight brightness adjustment
3 x 1 header, pitch 2.00mm
SW1
Multi-function select
DIP switch 4pin
Connectors
Label
Function
Note
CPU_FAN1
CPU fan connector
4 x 1 wafer, pitch 2.54mm
SYS_FAN1
System fan connector
4 x 1 wafer, pitch 2.54mm
SODIMM1
204-pin DDR3L SODIMM socket
JAUDIO
Audio connector
6 x 2 wafer, pitch 2.00mm
Seitenansicht 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 74 75

Kommentare zu diesen Handbüchern

Keine Kommentare