
ECM-LX800W Series
50 ECM-LX800W Series User‘s Manual
3.5.2.5 Quick Power On Self Test
This category speeds up Power On Self Test (POST) after you power up the computer. If it
is set to Enable, BIOS will shorten or skip some check items during POST.
3.5.2.6 First/Second/Third/Other Boot Device
The BIOS attempts to load the operating system from the devices in the sequence selected
in these items.
3.5.2.7 Swap Floppy Drive
While system has two floppy drivers installed, this item will be affected. This function is to
assign physical drive B to logical drive A.
Assign physical drive B to logical drive A
3.5.2.8 Boot up Floppy Seek
The system will detect and verify operation of the floppy drive type.
Enable the detection for floppy drive
Disable the detection for floppy drive
3.5.2.9 Boot Up NumLock Status
Select power on state for NumLock.
3.5.2.10 Gate A20 Option
Select if chipset or keyboard controller should control Gate A20.
A pin in the keyboard controller controls Gate A20
Lets chipset control Gate A20
3.5.2.11 Typematic Rate Setting
Key strokes repeat at a rate determined by the keyboard controller. When enabled, the
typematic rate and typematic delay can be selected.
Enable typematic rate/delay setting
Disable typematic rate/delay setting
Kommentare zu diesen Handbüchern